Tom for Model Number Maytag Dishwasher Model MDB9150AWB I just replaced the control panel on this dishwasher. I had to take out the PCB Assembly and put it into the new control panel. There is a green (I assume ground) wire that comes up from the wire harness to the PCB assembly I believe. I put it back where I believe it was on the PCB assembly but I want to make sure. There are two screws holding the right side of the PCB assembly to the control panel. I put the furthest right screw through the eyelet of the green wire and put that screw through the right hole on the PCB assembly. This hole is near what appear to be transistors. Is that the correct location? The screw and hole further to the left had no wires going to it if I recall correctly. Thank You, Tom
Answer Tom, As long as there is a piece of metal that the ground wire is attached to then it will be fine. Read More... Answered by AppliancePartsPros.com | Tuesday, December 24, 2013