Kp for Model Number Kenmore 110.85862400 Dryer has power. All lights and controls work. All normal in Diagnostic Mode. But, using any setting, when Start is pressed and held, dryer hums for about 5 seconds, then stops. No drum turn, no motor noise. Thermal fuse has continuity. Both motor windings show 1.9 Ohms. Belt Switch tests good. Resistance between P1-3 and P1-4 on Control Board shows OL (not sure what good reading should be, test sheet just says replace if between 2 and 6 Ohms) . Door Switch test in Diagnostics Mode shows good (beep on close and open, 4E code on display when open), BUT only get OL or very high resistance (15MOhms) between P1-3 and P1-2. So, conflicting results for Door Switch, everything else checks OK. Hard to believe a bad Door Switch would show good in Diagnostics Test, so guessing Control Board is issue. Your Thoughts?
Answer KP, Based on the information this would be an issue with the control board of the unit with getting OL reading. Read More... Answered by AppliancePartsPros.com | Monday, November 27, 2017