Herman for Model Number MGD9800TKO I need help I have a Maytag dryer that when you close the door and push the start button it beeps and it goes to sensing mode. but dryer never startscan it be the control board?
Answer HI Herman thanks for reaching outYes, the control board is possible, but I wouldn’t replace it yet. Since the dryer beeps and changes to Sensing when you press Start, the control is at least receiving the Start command. There are several other things I would check first.For Maytag MGD9800TK0, I’d go through these checks in this order:1. Check the door switchOpen the door and see if the drum light comes on. Push the door-switch lever in by hand; the light should go out.If it doesn't respond correctly, unplug the dryer and check the switch with your multimeter. It should change between continuity and OL as you operate the switch.2. Check the thermal fuseThis would be one of my first suspects for a dryer that powers up normally but won't run.Unplug the dryer and locate the thermal fuse on the blower housing. Disconnect at least one wire and measure across the fuse.You should get:Approximately 0 O/continuity = goodOL/no continuity = badIf the fuse is open, replace it and make sure the vent and exhaust system aren't restricted.3. Check the belt and belt switchMake sure the belt is still around the drum and properly tensioned by the idler pulley.The belt/idler operates a safety switch. If the belt breaks or the switch isn't closing, the dryer can power up and go into Sensing but the motor won't start.With the dryer unplugged, check the belt switch for continuity while manually operating its lever.4. Check the thermistorWhile you're at the blower housing, check the exhaust thermistor as well.Unplug the dryer, disconnect the thermistor wires, and measure resistance across it.At approximately 70–77°F, you should normally see around 10–12 kO.The resistance should also decrease smoothly as the thermistor gets warmer.Around 10–12 kO at room temperature = generally goodOL = open/bad thermistorNear 0 O = shorted/bad thermistorWay outside the expected range = suspect thermistorThe thermistor isn't as likely as the thermal fuse or motor safety circuit to cause your particular no-start problem, but it's easy enough to test while you're there.5. Check what happens when you press StartListen carefully.If you hear a click from the control area but nothing from the motor, the control may be trying to start the motor, and I would concentrate on the motor circuit, belt switch, wiring, and motor.If you hear the motor humming, unplug the dryer and see if you can rotate the drum by hand. It should turn with some resistance but shouldn't be locked up. A hum with no rotation can indicate a bad motor or something mechanically binding the drum/blower.6. Control boardI would move to the control board only after those checks pass. A board failure can certainly cause this, but replacing it before checking the safety and motor circuits can get expensive quickly.My troubleshooting order would be:Thermal fuse ? door switch ? belt/belt switch ? thermistor ? motor/motor circuit ? control board.If you have a multimeter, these tests should narrow it down without having to guess and replace parts. Read More... Answered by AppliancePartsPros.com | Tuesday, September 1, 2026