Patrick for Model Number KUDS01IJBS0 My Kitcheaid KUDS01IJBS0 dishwasher stopped working last week. I can press all the buttons and get the corresponding LED indicator to illuminate, but when I try to start a cycle it will not start. The seven segment displays both show "--" and when I press start nothing happens. I opened up the control panel and "ohmed" out the buttons and they all work, assuming the response I get on the meter is as expected. The value I read is around 30 ohms and it does jump around a bit. I made the measurements with power off and the ribbon cable connector disconnected from the control board. I also tried to run the diagnostics and that seemed to work. I am assuming a control board issue, but I wanted to make sure it is not something simple like a sensor stopped working. The issue did start when I noticed the add sani rinse indicator was stuck on. Not sure if that is related to the issue. It would help if I knew what all the connectors on the control board go to. Anyways any help is greatly appreciated. Thanks
Answer Hello Patrick, Since you have tested the touch panel, I would assume that, as long as something is not holding the flood float up, the control WP8564543 is the component with the issue. As a manufacturers' note: Per factory, this sub should only have 3 terminals. The P4(Y) terminal which was on the original control has been removed and not used on this control. Read More... Answered by AppliancePartsPros.com | Thursday, August 21, 2014