John for Model Number KUDM01TJWH0 KitchenAid. First it seemed to jump around to various cycles, as though it couldn't make up its mind what to do. I pulled the top panel off and there was evidence of a diode burned out and possibly an adjacent resistor. The board was burned and discolored in that area so I replaced it. All went well for a couple cycles, now nothing. When I press Normal/Start, it won't run and the Normal light just continues to blink. If I press Cancel/Drain, then both it and the Normal light will continously blink but nothing starts. Thoughts? Might it be the main panel that contains the push buttons with the ribbon attachment? I also did some continuity checks while apart using a Whirlpool schematic. Checking the drain motor between the blue-black wire and the gray wire, I get 17.5 ohms. Per the strip circuits diagram it should read 4.2-7.0 ohms. Could that have possibly blown the fuse mounted on the box the control panel board is located in? I haven't taken it apart again to test that fuse.
Answer John, As for the issue with the normal light blinking continuously would be a stuck key on the keypad and would need to be replaced. Also if the resistance of the drain is getting 17.5 ohms then the drain pump would be faulty and need replaced. Read More... Answered by AppliancePartsPros.com | Thursday, April 23, 2015