Stan for Model Number KUDMO1TJBT0 KitchenAid My KitchenAid dishwasher KUDMO1TJBT0 ran the wash cycle (normal), and went to rinse and heat. The rinse cycle would not stop. It would not go to Dry cycle. Had to open the door to get it to stop rinsing. I installed a new Electronic Control Board 8564543. The original board was 8528172. The new board was supposed to replace the original. Now the Normal light blinks and the Cancel light blinks and the dishwasher will not start. The blinking lights will not stop blinking even by opening the door. Had to turn off the breaker to stop the lights from blinking. What do you think is wrong? I also read other peoples questions and several times it read to turn off the power for a while and then turn the power back on to reset the control board. I tried this also and it did not change anything.
Answer Hello Stan. You will need to check and see if the ribbon cable has any moisture on it. If so, this issue will happen. Also, make sure the ribbon cable is installed properly in the unit. If so, you will need to replace the control panel WP8270226 in the unit. Read More... Answered by AppliancePartsPros.com | Wednesday, May 23, 2012