David for Model Number GU2500XTPS1 So, this started with the unit running long then it did finally stop. Ran again and it was running for over 2 hrs and still showing 45 minutes. So I stopped it, emptied it, etc. Ran diagnostic and it ran (no errors I could tell), but at the end it started fast flashing start/resume and showed -- with the normal light lit. Now based on reading things control board problem. I get a new controller board and install. Now, with either board, when I turn it on it instantly goes to "normal - heated dry - soaking". Does this for a minute or so (and water is flowing in) and then stops and shows -- with fast flashing start/resume. If I power on an immediately hit cancel/drain it will drain (showing 2) and then stop and never get to 1 and shows the -- with flashing start/resume. It does drain (mostly). I somehow got it to power on and have the display clear/standby (not sure how) and re-ran diagnostic. It ran through and then did same thing. When it is in the -- flash state hitting any key either does nothing or toggles the normal light on/off. Ideas? Maybe the key panel? Or ???
Answer Hello David. Yes, it sounds like the key panel will need to be replaced along with the board on the unit. Make sure the ribbon cable is seated good on the unit. Read More... Answered by AppliancePartsPros.com | Friday, April 1, 2016