Customer Questions and Answers for Refrigerator Water Dispenser Tube Kit by Whirlpool

Hello Ken. Here are the instructions from the manufacture. Hope this helps. Installation Procedure 1. Unplug refrigerator or disconnect power. 2. Remove existing water tube and/or bracket. 3. Install the bracket using the screw. 4. Slide tubing of the valve assembly into the water tube conduit. 5. Place heat staked joint portion of the valve assembly into the notch of the bracket. 6. Press the tip of the valve assembly into the bracket such that the bracket tab locks into the hole. 7. Remove slack in tubing by pulling from bottom of door. Verify that the valve assembly is vertical and seated properly in the bracket. 8. Cut tubing to appropriate length and connect to reservoir union. 9. Run several glasses of water through device until drum section is full. Drum fills only by cyclic dispensing not continuous dispensing. 10. Verify that there are no leaks at union or valve assembly.