Mike for Model Number 10655603400 Planning to order Part Number: AP3182503 and Part Number: AP3182733 I noticed that there is a white putty/adheasive where the black nozzle meets the square cut out inside the freezer wall above the ice maker fill cup. Is this putty/adheasive needed for a new installation. Also I need to replace my ice maker because the unit filler cup and the filler nozzle freezes up and over flows. I believe this caused the filler tube to crack causing a leak behind the top of the refrigerator where the filler tube comes out of. The installation seems straight forward. Removed the ice maker once already to defrost it. It filled with water but the ice ejector arm was frozen inside the ice cubes and the filler cup and nozzle froze again. Is there anything else I need or should know before I place my order. Thanks!
Answer Mike, Your replacement of the ice maker, is probably unnecessary, A frozen fill tube is usually due to a faulty fill valve W10408179, Yes, due to the routing of the water inlet tube to the ice maker, I would reccomend you use the existing Putty as a seal, to keep heated room air from infiltrating into the freezer compartment and causing a frost or freezing problem. You are correct, it is a pretty straight forward repair as far as the fill tube. Thanks and Good Luck. Read More... Answered by AppliancePartsPros.com | Friday, July 22, 2011