Customer Questions and Answers for Heating Element Kit by Whirlpool

Hello Wyatt. Please turn off circuit breaker to the unit. Then loosen the 2 heating element plastic nuts and lift each end of element up through the top side of the tub. Unhook the remainder of the element from the front tub holding clips. Using new element nuts part#WPW10477552. If your tub is stainless steel then order element kit part #8194200. For plastic tubs use part #W10518394. Remove the 6 screws holding the Electronic Control panel, tilting the panel forward and upward at the same time. Then unclip the fuse holder from the control board, reinstalling the new fuse with the existing fuse plastic cover shield. Then you observe all the wiring tab placements on the control board and reinstall wiring correctly the same, observing any newer instructions which may have been sent with the element kit which comes with the new control board. Hope this helps.