Lee T. for Model Number KTRS20KAWH10 Actually folks, you didn't read my entire previous question. If you had, you would have answered my question about the lack of 2 sepearate leads at the right rear bottom of the unit, where the water valve would go. There are no extra leads to which I would connect the water valve you provided in the kit. You should scrutinize the questions sent to you better as to not waste undue time. I did as you asked with the wire harnes and disconnected the one that came on the ice maker. When I did so, I took another look at the exisitng harness inside the freezer and noticed an additional plug (adapter) hooked to the end of the harness. When I removed that adapter, it revealed the correct connector that would indeed fit the small harness that came attached to the ice maker. So, that then is no problem. I have only the water valve problem to solve and I can get to work installing the ice maker.
Answer Thank You Lee for your response. It seems as if your model # came equipped with the adapter plug used in that particular series of you model and similar ones like yours. The manufacture used a certain water valve then that its terminals needed this said adapter. Thank You . Read More... Answered by AppliancePartsPros.com | Wednesday, March 21, 2012