George for Model Number Kenmore Washer 11027032603 My washer keep throwing a F50 code, it will not allow the washer to fill and if I go to the drain and spin cycle it will not spin. Any suggestions?
Answer Hello George. F then 50 flashes when the motor rotorposition sensor (RPS) senses no rotation.? Does basket turn freely? If not, make surebottom shipping pack has been removed.Determine cause of friction. This test checks the wiring to the motor and rotorposition sensor; and the motor and rotor position sensorthemselves.NOTE: Drain water from tub.1. See Activation of Manual Diagnostic Test Mode,page 3 and check the motor and electricalconnections by performing the Spin test underManual: Motor, page 2. The following steps assumesthat this step failed.2. Unplug washer or disconnect power.3. Check to see if basket will turn freely.? If basket turns freely, go to step 4.? If basket does not turn freely, determine what iscausing the mechanical friction or lock up.4. Remove the console to access the machine/motorcontrol assembly. See Accessing & Removing theElectronic Assemblies, page 6.5. Visually check that the P5 and P10 connectors areinserted all the way into the machine/motor control.? If visual checks pass, go to step 6.? If visual checks fail, reconnect P5 and P10 andrepeat step 1.6. Visually check that the P5 and P10 connectors areinserted all the way into the machine/motor control.? With an ohmmeter, verify resistance values. Read More... Answered by AppliancePartsPros.com | Tuesday, July 23, 2013