Don for Model Number WTW7600XW0 When I start a wash cycle the fill valve opens starts the fill for a few seconds and then stops. I can hear the other valve still running for a few more seconds and it then stops. The washer then goes into a slow spin cycle and then stops. It will then again go into a slow spin cycle again. It never goes into the fill cycle to continue the fill. I have run the diagnose test several times. All the fill valves seem to work but I don't get any error codes at any time. I was thinking it might be the water level sensor. But it looks like it might be part of the control board. Not sure what else it could be. The door lock works and all the buttons and control knob seem to work for the different settings. I have tried the different settings and all seem to work. any help or advice would be appreciated. Don
Answer Don, Based on the information it sounds like it will be caused by a faulty control board that is causing this issue. Read More... Answered by AppliancePartsPros.com | Friday, January 27, 2017