Customer Questions and Answers for Electronic Control Board by Whirlpool

Best Seller

Manufacturer Part

Electronic Control Board

4.89 (64)

By: Whirlpool

Part Number: OEM18057246

Manufacturer Part Number: WPW10299400

Questions & Answers

For Whirlpool Electronic Control Board (Part Number: OEM18057246)

Linda December 28, 2021 for Model Number WTW7340XWD

Washer fills and runs for a period of time. Timer starts skipping back and forth on amount of time left. After doing this several times, it stops and gives F 1 or 2 code, still filled with water. It does not do anything else, just sits and flashes. Tried resetting, unplugging and resetting, it repeats the same thing. It will empty using the drain and spin cycle, skipping the programmed cycles. Problem occurs with about 50 minutes left in the cycle. Trouble shooting guide indicates control panel.

Linda, if there is not a partial clog at the pressure hose where it connects into the tub and there is not a pinched wire or hose, the machine control WPW10299400 would be the cause of failure. Unfortunately, the control has been discontinued by the manufacturer and is no longer available.

Don January 23, 2017 for Model Number WTW7600XW0

When I start a wash cycle the fill valve opens starts the fill for a few seconds and then stops. I can hear the other valve still running for a few more seconds and it then stops. The washer then goes into a slow spin cycle and then stops. It will then again go into a slow spin cycle again. It never goes into the fill cycle to continue the fill. I have run the diagnose test several times. All the fill valves seem to work but I don't get any error codes at any time. I was thinking it might be the water level sensor. But it looks like it might be part of the control board. Not sure what else it could be. The door lock works and all the buttons and control knob seem to work for the different settings. I have tried the different settings and all seem to work. any help or advice would be appreciated. Don