Scader for Model Number SVE47600B About two months ago a service company installed a new sensor. It was working fine until lately we get repeated F5 error codes. Typically, if we let the oven rest for a few hours it works fine afterwards. According to the wire diagram located on the oven, this is oven caused by a loose connection of the sensor. I figured the service company failed to properly seat the new sensor. Thankfully, the sensor removes from inside the oven as the oven itself it set into the counter top. I removed the "new" sensor and discovered that the plastic connection between the sensor and the adapter is brown and a even slightly melted. The connector to from the adapter to the rear wire looks fine. I don't know how this is possible as all those components are pushed into the back of the oven behind the sensor. Any thoughts? I'm concerned that if I buy a new sensor that it will just melt like the previous.
Answer Hello Scader. This usually happens during the self cleaning cycles and ifs from the extreme heat. There is nothing that can be done, other than not using the self cleaning cycles in the oven. If the sensor is bad, you will need to order and replace the sensor 12001656 in the unit. Read More... Answered by AppliancePartsPros.com | Thursday, September 6, 2012