Maddmatt for Model Number Kitchenaid start relay (pn 10097204) Thanks for your quick response to my previous question. Here's my issue, my Kitchenaid KTRS19KFWH01 refridgerator has only one white wire leading to the start relay pn 10097204 (not the overload, that's a seperate unit with a red lead.) There is no run capacitor with a 2nd white lead located anywhere in the units lower component compartment. The start relay has 3 lug connections which are numbered 1, 2, and 3. The white lead was disconnected from the relay and there it no wiring diagram to indicate where the lead should be connected. Lugs 1 and 2 are located to the right, vertical to one another, and lug 3 is located opposite to them on the upper left of the relay when facing it upright. The appliance runs with the white lead connected to lug 1, but I'm not 100% certain that it belongs there. I'm trying to be sure that this unit opporates correctly and safely. Thanks again!
Answer Hello Maddmatt. That is correct, the white wire goes to terminal 1 on the relay. It will only run if the wire is connected in the correct location. Hope this helps. Read More... Answered by AppliancePartsPros.com | Saturday, September 3, 2011