Customer Questions and Answers for Panel- Con by Whirlpool

Daniel, You will need to check the wiring and door switches,and replace the control panel 6-919765 to solve your issue. You'll need to dismantle the door assembly and control panel(s): 1. Disconnect power to the machine. 2. Open the Dishwasher door. 3. Remove the 11 Torx™ screws along the sides and top of the Inner Door Panel. 4. Separate the Inner Door Panel from the Outer Door. 5. Disconnect wires from the Dispenser Wax Motors before pulling the Inner Door Panel away from the Dishwasher.PC Board Removal 1. Disconnect power to the machine. 2. Remove the Inner Door Panel. 3. To access PC Board, remove 1/4" screw on PC Board Housing Cover. 4. To remove PC Board, loosen (2) 1/4" screws securing PC Board Base to Control Panel. 5. Remove pin and ribbon connectors from PC Board. 6. Depress tabs on PC Board Housing to remove PC Board. 1. Disconnect power to the machine. 2. Remove the Inner Door Panel. 3. Remove PC Board Housing Cover. 4. Disconnect Membrane Switch from PC Board. 5. Remove PC Board Base. 6. Lift out Latch Assembly. 7. Remove 4 screws securing Control Panel to Outer Door. NOTE: Facia is susceptible to damage during reinstallation. You will also need to remove the outer door panel it will need to slide up and off the outer door panel, once you remove the interior screws from the inner door / hinge panel. Thanks and Good Luck