David for Model Number Whirlpool Calypso washer My Whirlpool Calypso washer was stalling during the rinse and spin cycles, repeatedly trying to start up and stopping, sometimes finishing the load. Automatic diagnostic mode gave no errors, and I was able to use the manual diagnostic mode to get the machine to rinse and spin. Then the next time, there were no lights on the display panel at all and no response. Everything I read seemed to indicate a bad main control board, which I replaced even though it had 120V between pins 2 and 4 at connector P16. There is still no display w/ the new board, and I still have 120V between pins 2 and 4. Does it sound like the original problem was the control board? Is it possible I had a bad control board that burned out the display, and now I have to replace that too? Thanks for any help.
Answer David, It is possible that the issue was with the control board but it sounds more likely that the control panel was the issue and would need to be replaced. Read More... Answered by AppliancePartsPros.com | Thursday, March 9, 2017