Drew for Model Number wtw6300sw1 I have a whirlpool cabrio washing machine that i had stored in a storage unit for a year and was exposed to extreme heat and cold. Now i am trying to use it again and it is going through the wash cycle fine and draining the water out fine but when it tries to go into rinse cycle it doesnt do anything for a while and then throws up an "LD" error. i have tried unplugging it and replaceing the pump and that hasnt helped. Im almost sure its one of the control boards but not sure if it the green or gray one. If you could give me some advise I would appreciate it. thank you
Answer Drew, The "LD" or F32 error code, indicates > Long Drain > Ld flashes when the water level does not change after the drain pump is on. ? Is the drain hose or the drain pump clogged ? Is the drain hose height greater than 96" ? ? Is the pressure hose connection from the tub to the machine/motor control pinched or plugged?? Is the pump running? You will need to roll over the control panel, carefully disconnect the clear plastic air tube and blow in it to check and make sure it's not clogged with debris or deposits, from setting so long. Here's some help," 1. Unplug washer or disconnect power. 2. Remove the three hex-head mounting screws from the rear of the console.3. Lift the console off the cabinet, and roll it forward." Good Luck and Thanks Read More... Answered by AppliancePartsPros.com | Thursday, January 26, 2012