Doug for Model Number MFI2568AES There is no water to the ice maker. The water tap for the door works just fine. I was going to try to remove the ice maker and see if I can find the water entry point to check for a plug or to see if it is frozen. I can not figure out how to remove the ice maker. I removed the 3 screws that hold the auger motor. It also looks like I need to remove the screw that holds the finger that spins the auger. Are there any other screws that hold the ice maker? Where can I find a schematic drawing? I also see a plastic tab on the left side. Do I just "pull hard" to remove? If the inlet is not frozen - what should I try next?
Answer Hello Doug. Here are the instructions from the manufacture. Hope this helps.Removung the icemaker.1 Remove ice bucket2 Remove icemaker wire harness by inserting a flat blade screwdriver into the slot on the cover on the left. Push up on screwdriver and pull cover to release.3 Disconnect icemaker wire harness.4 Release locking leaver and slide the icemaker assembly out of the box.5 Remove the screws holding the icemaker to the impinger.6 Remove the icemaker from the impinger. Read More... Answered by AppliancePartsPros.com | Tuesday, April 5, 2011