Jf for Model Number 10657762791 The ice in my ice maker is stuck halfway and is not dispensing into the tub. My tub has an auger attached to it that then dispenses through the door of the freezer. Next to the ice dispenser is a water dispenser which is also built into the door. I suspect, based upon my research, that the best bet for fixing my problem is to replace the entire ice maker. However, your description of the ice maker for my model says, "This model does not fit refrigerators that have the ice auger assembly mounted on the door and the electronic sensor to sense ice level." Item Number: AP2984633 As stated above, my auger is mounted on the ice tub which is next to the door. Also, my ice maker has an arm assembly to sense the level of ice in the tub. Will this ice maker fit in my refrigerator? Read more: http://www.appliancepartspros.com/Appliance-Parts/whirlpool-whirlpool-icemaker-kit-item-number-ap2984633.aspx#ixzz257nZMu74 http://www.appliancepartspros.com "
Answer Hello J.F., The complete ice maker will correct the issue more cheaply than replacing the individual parts that will probably be required. The mold heater is most likely bad and the thermostat is part of the issue. The control module has probably sustained damage from the unit being run out of time. It would be cheaper to replace the ice maker assembly 4317943. Read More... Answered by AppliancePartsPros.com | Tuesday, September 11, 2012