Kris for Model Number WDT790SAYM3 I have strange issue with my whirlpool gold series dishwasher. When I run my dishwasher, I see its filling the water properly, and heating it up, opens the soap lid and it stops there. It doesn't initiate clean cycle. But after some time, it drains the water and fills new water and heats it up, without washing. This happens couple of time and finally it stops without cleaning. The strange part is, once I do system reset by pressing 123123123 process, then the first iteration, my dishwasher works perfectly. It cleans and drains. On the next day, again it shows the problem of stopping after filling water. I suspected the problem could be computer, turbudity sensor, so replaced them. Still issue is same. First iteration goes clean, second iteration it gets stuck. Checked door latch, motors individually, they are working fine. Presently my work around is, every day reset the system (123123123 steps), before initiating wash cycle. This way, I am getting my dishwasher work. Not sure, what is happening here. Please help.
Answer Kris, Based on this issue, check to make sure that the float switch is not sticking and if it is not then this would most likely be a faulty main control board or a wiring issue. Read More... Answered by AppliancePartsPros.com | Thursday, April 22, 2021