Jim for Model Number Whirlpool Dishwasher WDT710PAYW6 My unit is not draining properly. I have checked all hoses and housings. Have cleaned inside pumps both pressure and draining. Motors are working. When I put it back together, I left the filter screen out (screen is clean) and ran water into the unit. I pushed the drain/cancel button and within 30 seconds the water was drained and unit was empty. I installed the filter and again filled the bottom inside with water and hit the drain/cancel button. The unit wouldn't drain, although you could hear the drain motor doing something. Could this problem be the turbidity sensor? Are there any other sensors inline before this sensor? I have taken the sensor out and used a toothbrush to clean it. No luck. Any suggestions? Thank you, Jimmy
Answer Hello Jim, the drain pad forces the control to run a 3 min drain out regardless of anything, the sensor is only used in a wash cycle. Based on your checks suggest you replace the filter W10872845 first. if still occurs replace the drain pump WPW10348269. Read More... Answered by AppliancePartsPros.com | Monday, July 12, 2021