Kim When I start the washer, the acuater moves from 4 to 1. However it moves from 1 to 2 to 3 to 4.. it stops on all 4. Nothing is dispensed. no water, not detergent, It doesnt spin or do anything. It will then cut off and then show the f13 code.
Answer Hi Kim., Here's what I've found on the F-13 fault code: F13 Dispenser circuit error If the dispenser motor is not able to be driven to it’s proper position. Potential Causes • Check mechanical linkage from dispenser motor to the top of the dispenser. • Check Wire Harness connections to the dispenser motor and Central Control Unit (CCU) • Check Dispenser Motor Replace failed component. What this bit of information doesn't mention is that the control which is giving the fault code is using a self-diagnostic circuit. This self-diagnostic circuit is a man made circuit which can fail also. If, after you double check the dispenser, you cannot find a definate problem, the control WP8182695 is a consideration for replacement. Don't buy a control until you have thouroghly checked the dispenser as it is easy to overlook something. The most common part for replacement is part # WPW10665207. Thank You. Read More... Answered by AppliancePartsPros.com | Wednesday, May 2, 2012