Steve1147 for Model Number GHW9150PWO My washer would run up to rinse, then shut down and show F-13. I ordered and replaced the dispenser actuator assembly. With the top off I watched, it now starts and washes all at position II, then when it hits rinse, the dispenser motor sweeps the pointer back and forth from I to IV pausing very briefly at each number, and after several full passes, shuts down again with error code F-13, what can cause this? Thanks! Steve W.
Answer Hello Steve, Here's what I've found on the F-13 fault code:F13 Dispenser circuit error If the dispenser motor is not able to be driven to it’s proper position.Potential Causes• Check mechanical linkage from dispenser motor to the top of the dispenser.• Check Wire Harness connections to the dispenser motor and Central Control Unit (CCU)• Check Dispenser MotorReplace failed component.Read more: http://www.appliancepartspros.com/repairtips/repairtips_appliance+fault+codes.aspx#Whirlpool'>http://www.appliancepartspros.com/repairtips/repairtips_appliance+fault+codes.aspx#Whirlpool Duet Front Loading Automatic Washer Fault Codes#ixzz1tG7RVDqyhttp://www.appliancepartspros.com What this bit of information doesn't mention is that the control which is giving the fault code is using a self-diagnostic circuit. This self-diagnostic circuit is a man made circuit which can fail also. If, after you double check the dispenser, you cannot find a definate problem, the control WP8182695 is a consideration for replacement. Don't buy a control until you have thouroghly checked the dispenser as it is easy to overlook something. Read More... Answered by AppliancePartsPros.com | Friday, April 27, 2012