Customer Questions and Answers for Limit Switch by Whirlpool

Phil, Here is the help you need : "Ice and Water Fountain Bracket Assembly Removal 1. Disconnect the unit from the power source. 2. Pull straight out to remove the grill from the fountain sump. 3. Remove the two escutcheon mounting screws. 4. Raise the escutcheon up and off the fountain assembly. 5. Disconnect the quick disconnect edge connector from the PC fountain switch board. 6. Remove the three fountain bracket mounting screws. Checking and Replacing the Actuator Switch: 1. Disconnect the unit from the power source. 2. Perform steps 1 through 6 of To Remove Ice and Water Fountain Bracket Assembly. 3. Check the continuity of the switch if defective go to step 4. 4. Remove the mounting screw. 5. Remove the switch. 6. Remove the wire leads. 7. Install new switch in reverse order of removal. Thanks and Good Luck