G I have replaced all venting from the dryer to the outside. I have replaced the thermal fuse mutiple times. Dryer will work 10 to 20 days until the Thermal fuse blows. I have vacuumed all the interior duct in the dyer and can find no restrictions. Dryer has work in this location for 10 years no problems. I thought it may be the thermostat but I can observe the element cycling. Any help would be greatly appreciated. Thanks, G
Answer G, You forgot to attach a model number. but, in general, there other things to check or replace. With the new venting, and you're sure there are no kinks or restrictions and the vent hood is not too close to the ground or collapsed, you'll need to first check for and remove any lint build up in the air duct assembly and blower housing 37001141, check and make sure the blower wheel 56000 and vanes are clean, not cracked and the wheel fits tight on the motor shaft. and there are no air leaks around either drum seal, and blower inlet seal. This time, repalce both the thermal fuse WP40113801 and high limit switch WPW10116735 at the same time. Read More... Answered by AppliancePartsPros.com | Thursday, September 20, 2012