Dennis B for Model Number MDE8400AYH The following is question and your reply. It does not seem to be correct. The timer does NOT have any mounting screws. It is a slide in bracket as shown on your site. Model # MDE8400AYH Serial # 23219926EC Part Number 33002855 Timer. I cannot figure out how to remove knob to replace the timer. Can someone help please? Dennis B. Asked by Dennis B. for Model Model # MDE8400AYH Hello Brandon! Here is the timer removal/replacement according to the service manual for your unit. Hope this helps, thanks! TIMER REMOVAL: 1. Disconnect power to the unit. 2. Carefully lift the timer knob and dial off the timer by pulling the knob away from the control console. 3. Remove the two timer mounting screws (now exposed on the control console) when the timer dial skirt is removed. 4. Disengage the console assembly from the top cover and roll forward. CONSOLE REMOVAL 1. Disconnect power to the unit. 2. Remove the four screws securing the console to the rear cover plate. 3. Lay a drop cloth across the top cover of the washer. 4. Grasp the top of the console and gently rock the top of the console forward away from the rear console back. Note the hooked tabs on bottom of the console, which engage the slots in the top cover 5. For reinstallation, reverse the aforementioned steps.
Answer Hello Dennis. Remove the center cap from the timer knob by pulling it out. Once the center cap is removed, the timer knob and skirt will pull off of the timer shaft. Once these are removed you can replace the timer. Thanks. Read More... Answered by AppliancePartsPros.com | Wednesday, September 19, 2012