Liketofixitmyself for Model Number 110.44832202 Kenmore Elite H3 I replaced this valve (easy to replace - the top of the washer comes right off with just a few screws), but it did not fix the problem. The washer still seems to think every load needs to be washed in hot. Any other suggestions? I am putting my original question here too."My washer only fills with hot water in the wash cycle, no matter the setting. The hoses are not switched, and the cold rinse cycle still tries to draw from the cold tap only. If I put the "hot" hose on the cold tap I can run a load in cold water. The cold rinse cycle draws only from the cold hose, so I have to switch the hoses back again. Is this the right part to fix this?"
Answer Liketofixitmyself, I wouldn't expect the fill valve to be the issue, until you varify the fill valve solenoid has a resistance reading (500 to 1000 ohms) and you have voltage (120 vac) to the cold solenoid from the control assembly(CCU). But the fill valve is a very good place to start. Good Luck and Thanks Read More... Safety note: testing, adjusting or bypassing anything while the appliance has power is a job for a qualified technician. Unplug it before you open it up, and keep it unplugged until every panel is back on. Answered by AppliancePartsPros.com | Tuesday, January 17, 2012