Peter for Model Number 110.25102310 Hello, I have a Kenmore series 500 auto load sensing washer (no selection for small, med and large loads) that does not fill the basin with enough water for the clothes inside the washer. The water is on and the lines are unobstructed. what part would I need to replaced to correctly sense the load in the washer? Thank you!
Answer Peter, as this model is a High Efficiency model, it can be common for a little bit of the clothing to be exposed above the water fill line. However, if less than half of the clothes are above the water level, the water valve WPW10683603 would need to be checked to ensure that there is proper water flow from both the cold and the hot side. If there is, the failure would likely be in the pressure sensor built into the main control W10582044. Read More... Answered by AppliancePartsPros.com | Thursday, April 29, 2021