Parts for Kitchenaid KFP0922WH0: 02 - Attachment Parts

This adapter is a factory-fit connector that joins mating components in your appliance to restore a secure, properly aligned connection. Replacing a worn or missing adapter helps ensure dependable operation and a proper seal where applicable. What it does

• Provides the correct interface between two parts for proper fit and alignment
• Helps maintain a tight seal at the joint to reduce gaps or leaks where applicable
• Restores stability to prevent loosening, vibration, or rattling at the connection point
• Replaces cracked, warped, or missing adapters that can cause connection issues

• Includes 1 adapter

• Disconnect power; shut off water or gas before servicing
• Note orientation of the original adapter to match during reassembly
• Seat the adapter fully; inspect any related clamps or O-rings used by your model and replace if worn
• After reassembly, restore utilities and check for proper operation and any leaks or vibration at the joint

This pusher is a small mechanical component that transfers motion and keeps mating parts aligned within its assembly. Replacing a worn or broken pusher restores smooth travel and reliable engagement so the mechanism operates as designed. What it does:

• Transfers motion to a lever, switch, or linkage to initiate movement
• Helps maintain alignment and smooth, repeatable travel of mating parts
• Restores proper engagement to reduce sticking or binding
• Typical signs it's failing: cracked or missing piece, intermittent operation, excessive force needed, or visible wear

• Pusher only

• Disconnect power; turn off water supply before servicing
• Access the assembly and note the pusher's orientation; take a reference photo
• Transfer any springs/clips from the original and securely seat the new part
• Manually check for free movement before reassembly and test operation

This replacement pusher fits the refrigerator's ice dispenser/ice-bucket assembly and helps drive the mechanism that moves ice through the chute. Replacing a worn or broken pusher restores smooth, reliable ice dispensing.

• Engages the dispenser/crusher linkage to advance ice from the bucket toward the auger and chute
• Supports crushed/cubed selection on models equipped with that feature
• Wear or breakage can cause weak or no dispensing, jamming, or being stuck in one mode
• Visible cracks, deformation, or missing plastic are common failure signs

• Disconnect power to the refrigerator; remove the ice bin
• Access the ice bucket/dispenser mechanism and note the original pusher's orientation before removal
• Reuse existing screws/clips as needed and confirm the mechanism moves freely after installation
• Reinstall the bin, restore power, and test both cube and crush dispense modes

This pusher fits into the appliance's feed opening or chute and is used to safely advance contents during operation. Replacing a damaged or missing pusher restores smooth feeding and helps prevent jams or erratic performance.

• Guides items through the feed tube/chute toward the working mechanism
• Helps maintain consistent flow and control during use
• Direct replacement for a cracked, warped, or lost pusher
• Common symptoms: items won't advance, frequent jams, needing to force contents, visible damage to the pusher

• Disconnect power before servicing the appliance
• Access the feed opening/chute and remove any broken remnants or obstructions
• Align the pusher with the guide and insert fully; do not force against resistance
• Test operation with a small amount of material