Parts for Electrolux E30DF74GPS1: 03 - Backguard Parts

Replace a cracked, stripped, or missing control knob on your range or cooktop. Restores reliable turn control for burners and oven functions.

Control knob for gas range burner or oven temperature selection. Replaces cracked, broken, or missing knobs. Attaches to control valve stem on front panel.

Control knob skirt for gas ranges. Decorative trim ring that fits around the control knob base. Replace if cracked, discolored, or missing.

Decorative skirt ring that fits around cooktop control knobs. Replace if cracked, discolored, or missing to restore the finished appearance of your range.

Fix an unresponsive control panel or oven that won't heat with this electronic control board. Regulates oven functions and temperature control. Moderate DIY repair.

Specs: 8 - 18 x 0.500

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head

This wiring harness is the appliance's main electrical connector assembly that routes power and signals between components, restoring reliable electrical connections for normal operation. What it does:

• Carries power and control signals between major components to enable normal appliance functions
• Replaces damaged, frayed, or burnt wiring that can cause intermittent operation or component failure
• Helps eliminate shorts or open circuits that prevent parts from receiving power
• Restores factory-style plug-and-play connections when original harness is corroded or broken

• One wiring harness assembly as pictured

• Disconnect power to the appliance before beginning any repair
• Match connector shapes and wire colors; route and secure the harness following original clips and channels
• Inspect mating connectors and grounding points for damage or corrosion before reconnecting