Parts for Frigidaire 30-4182-23-01: 02 - Backguard Parts

Black right-side end cap for range control panels. Replaces cracked, broken, or missing endcaps that leave control panel edges exposed or unfinished.

A decorative black end panel that covers the left side edge of your range for a finished appearance. Located at the left end of the range when viewed from the front, it should be replaced when cracked, discolored, or damaged, affecting the appliance's appearance.

This part has been discontinued and is no longer available.

This manifold panel is the replacement cover that mounts over the appliance manifold to protect internal tubing and provide the finished surface for controls. Restores proper fit and appearance after damage or wear. What it does:

• Covers and protects the manifold and associated tubing from debris and accidental contact
• Provides the finished mounting surface for control components and trim
• Helps maintain correct alignment of control openings and knobs
• Commonly replaced when the panel is dented, cracked, missing, or has broken mounting tabs

• Disconnect power (and gas supply on gas models) before starting any repair
• Use care handling sharp edges; wear gloves to avoid cuts
• Removal typically requires lifting or removing the cooktop/control assembly
• Secure all mounting tabs and fasteners; do not force mismatched parts

This trim/vent is the decorative grille that installs on the refrigerator front to cover and direct airflow around the lower service area, restoring appearance and proper ventilation. Durable plastic matches factory fit and finish. What it does:

• Covers the lower front/service opening and hides internal components for a finished look
• Helps direct airflow around the condenser/vent area for normal operation
• Replaces cracked, broken, or warped trim that can catch dirt or snag floor mats
• Restores secure mounting where clips or tabs have failed

• One trim/vent grille

• Remove power to the appliance before starting any work
• Usually installs by lining up tabs and snapping into place; use care to avoid breaking plastic clips
• If mounting clips are damaged, replace them before reinstalling the trim
• No special tools typically required;

Size: 8-18ab x 0.5 inch.

Specs: 8 - 18 x 0.500