Parts for Frigidaire 30TESKWED2: 02 - Backguard Parts

This trim wrapper is the outer decorative trim piece that finishes the appliance opening and protects internal edges for a clean, finished look. It restores appearance and helps keep seals and components covered. What it does:

• Covers and protects the exposed edge of the appliance opening for a finished appearance
• Helps keep surrounding seals and components shielded from spills and debris
• Replaces cracked, bent, or cosmetically damaged trim that affects appearance
• Restores the proper fit and alignment of adjacent panels when the trim is the cause of gaps

• Trim - wrapper

• Disconnect power or unplug the appliance before starting any repair
• Remove adjacent panels or fasteners as needed; retain all screws and clips for reassembly
• Handle edges carefully—trim pieces and mounting points can be sharp
• Compare mounting tabs and screw locations to the original part before final installation

The Surface Unit Switch Kit is an OEM part for Frigidaire ranges. It controls the power and heat levels to the surface burners on the cooktop, allowing you to adjust the temperature for cooking. This kit typically includes the necessary components to replace a faulty switch and restore proper functionality to the burners.

Causes of a bad surface unit switch can include electrical malfunctions, wear and tear from regular use, or damage due to spills or impacts. A faulty switch can prevent the burner from heating correctly or at all.

Symptoms of a bad surface unit switch include:

• Burners not heating up or heating unevenly
• Inability to adjust the burner temperature
• Burners not turning on or off properly
• Sparks or electrical odors near the switch

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.

The Surface Unit Switch Kit is an OEM part for Frigidaire ranges. It controls the power and heat levels to the surface burners on the cooktop, allowing you to adjust the temperature for cooking. This kit typically includes the necessary components to replace a faulty switch and restore proper functionality to the burners.

Causes of a bad surface unit switch can include electrical malfunctions, wear and tear from regular use, or damage due to spills or impacts. A faulty switch can prevent the burner from heating correctly or at all.

Symptoms of a bad surface unit switch include:

• Burners not heating up or heating unevenly
• Inability to adjust the burner temperature
• Burners not turning on or off properly
• Sparks or electrical odors near the switch

This OEM replacement is also compatible with Electrolux, Gibson, Kelvinator, and Kenmore models.