Parts for Frigidaire CGEF306TMFA: 03 - Backguard Parts

Plastic endcap that covers and protects the side edge of your range control panel. Replace if cracked, broken, missing, or discolored to restore appearance.

Fix F20 error codes, unresponsive touchpads, or inaccurate oven temps. This range electronic control board manages console functions and displays.

This control panel houses the timer and control mechanisms that allow you to select cooking functions and set operation times for your range. It contains the switches, timer motor, and wiring needed to operate oven and cooktop functions. Replace this assembly if cooking times are inaccurate, controls don't respond, or if mechanical timers stop advancing.

Replace your range's control knob when cracked, broken, or missing. This knob installs on the control panel to operate burners or oven settings.

This is a small lock washer used in range and oven assemblies to secure fasteners and prevent them from loosening due to heat and vibration. It is commonly used in mounting hardware for controls or other internal components. Replace this washer if it is deformed, cracked, or no longer holds the associated bolt or screw tightly in place.

Secures burner or oven control to the control panel behind the knob. Replace if stripped, missing, or loose to keep control shaft stable and aligned.

This oven potentiometer assembly controls the temperature settings for your range's oven. It regulates the electrical signal that determines how hot your oven gets when you adjust the temperature dial. Replace this part if your oven won't heat to the correct temperature or if the temperature control knob doesn't respond properly.

This wire harness is the factory replacement wiring assembly that reconnects electrical components for reliable power and signal flow. It restores proper connections where damaged or worn wiring causes intermittent or failed operation. What it does:

• Carries power and control signals between appliance components so circuits work as designed
• Replaces damaged, frayed, or burnt wiring that can cause intermittent operation or component failure
• Helps resolve symptoms such as no power to a component, intermittent operation, or fault/error codes related to open or shorted circuits
• Maintains factory connector fit and routing to prevent loose connections and arcing

• Always disconnect power to the appliance before starting work to avoid shock or damage
• Compare the new harness to the old one to confirm connector types, lengths, and clip locations before installation
• Route and secure wiring per the OEM routing to avoid chafing, pinching, or contact with hot surfaces

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.