Parts for Frigidaire CPES3085KF5: 03 - Backguard Parts

Replacement control panel touch pad for ranges. Installs on the front console. Needed when original is cracked, faded, peeling, or unresponsive.

Round control knob for electric range burner or oven selection. Replaces worn, cracked, or missing knobs to restore grip and clear pointer marking.

Replacement trim panel for your range. Installs on the exterior to cover gaps or damaged areas. Order if your original panel is cracked or missing.

Replace the main chassis frame for your electric range. This structural part supports internal components. Order a new frame if yours is cracked or damaged.

Secures the control panel assembly on your range. Replace if the mounting lock is cracked, broken, or missing to restore proper panel stability.

Secures burner or oven control to the control panel behind the knob. Replace if stripped, missing, or loose to keep control shaft stable and aligned.

Fix error codes and beeping on your range. This main control board restores burner and oven operation. DIY repair takes 30-45 minutes with basic tools.

Replacement wire harness for your range. This wiring assembly connects electrical components inside the appliance. Order a new harness if yours is damaged.

Replace your range's worn or damaged wire harness. This internal wiring component connects electrical systems within your range. Order today.

Mounting screw for electric range, oven, or wall oven assembly. Secures internal components and panels. Replace if stripped, missing, or damaged.

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head