Parts for Frigidaire FGF378WCCG: 02 - Backguard Parts

This instrument mounting plate secures the appliance control or instrument cluster inside the cabinet, keeping electronic components aligned and stable for reliable operation. It helps restore proper fit and prevents movement that can cause noise or poor connections. What it does:

• Provides a firm mounting surface for the control board or instrument cluster
• Keeps connectors and wires properly positioned to maintain electrical connections
• Reduces vibration and rattling from loose or damaged mounting points
• Restores alignment so buttons, displays, and knobs operate correctly

• One instrument mounting plate

• Disconnect power before starting any repair to avoid electrical shock
• Retain or reuse original screws unless replacements are specified; verify screw sizes before installation
• Handle edges carefully; mounting plates may have sharp edges
• Check alignment and connector seating before reassembling the cabinet panels

Black right-side end cap for range control panels. Replaces cracked, broken, or missing endcaps that leave control panel edges exposed or unfinished.

A decorative black end panel that covers the left side edge of your range for a finished appearance. Located at the left end of the range when viewed from the front, it should be replaced when cracked, discolored, or damaged, affecting the appliance's appearance.

This electronic circuit board is located behind the range's control panel and manages oven functions including temperature control, timing, and cooking modes. Replace when the oven won't heat properly, displays error messages, or the control panel becomes unresponsive.

The range timer knob shaft is the rotating rod that connects the timer control knob to the internal timer mechanism behind the control panel. Replace when the timer knob spins freely without engaging, feels loose, or the timer won't advance properly.

This trim/vent is the decorative grille that installs on the refrigerator front to cover and direct airflow around the lower service area, restoring appearance and proper ventilation. Durable plastic matches factory fit and finish. What it does:

• Covers the lower front/service opening and hides internal components for a finished look
• Helps direct airflow around the condenser/vent area for normal operation
• Replaces cracked, broken, or warped trim that can catch dirt or snag floor mats
• Restores secure mounting where clips or tabs have failed

• One trim/vent grille

• Remove power to the appliance before starting any work
• Usually installs by lining up tabs and snapping into place; use care to avoid breaking plastic clips
• If mounting clips are damaged, replace them before reinstalling the trim
• No special tools typically required;

Support plate for range spice rack. Mounts inside the range to secure the spice rack assembly. Replace if cracked, broken, or missing for proper support.

Phillips head mounting screw for dishwashers and ranges. Secures internal components and panels. Replace if stripped, rusted, or missing during repairs.

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.