Parts for Frigidaire TGF357CCSE: 02 - Backguard Parts

This inner backguard shield is the replacement metal panel that sits inside the stove/oven backguard, protecting internal wiring and components while restoring the appliance's appearance. It replaces a bent, rusted, or missing inner shield. What it does:

• Covers and protects control-area wiring and components from heat, grease, and debris
• Restores the backguard's finished look and prevents gaps behind controls
• Stops rattling or vibration caused by a loose or damaged inner panel
• Helps maintain safe airflow behind the control assembly

• One inner backguard shield

• Disconnect power (unplug or shut off breaker) before removing the backguard or working near controls
• Remove exterior backguard trim and mounting screws to access and replace the inner shield
• Handle edges carefully — the metal panel may have sharp edges
• Keep all screws and fasteners; verify fit before final reassembly

This electronic circuit board is located behind the range's control panel and manages oven functions including temperature control, timing, and cooking modes. Replace when the oven won't heat properly, displays error messages, or the control panel becomes unresponsive.

This white canopy/shield trim restores the finished appearance of the appliance's hood area and helps cover mounting edges for a cleaner look. It replaces a cracked, dented, or missing trim piece. What it does

• Covers and protects the front edge of the canopy/hood for a finished appearance
• Hides mounting hardware and gaps left by damaged or removed trim
• Helps prevent debris from collecting in exposed gaps along the canopy
• Common symptom: visible cracks, dents, paint chips, or a missing trim piece

• Turn off power to the appliance before servicing to avoid injury
• Typically installs by aligning tabs and securing with existing screws or clips; do not force into place
• Keep original fasteners; replace only if damaged and if exact replacements are required

The range timer knob shaft is the rotating rod that connects the timer control knob to the internal timer mechanism behind the control panel. Replace when the timer knob spins freely without engaging, feels loose, or the timer won't advance properly.

This part has been discontinued by the manufacturer and is no longer available.

This trim/vent is the decorative grille that installs on the refrigerator front to cover and direct airflow around the lower service area, restoring appearance and proper ventilation. Durable plastic matches factory fit and finish. What it does:

• Covers the lower front/service opening and hides internal components for a finished look
• Helps direct airflow around the condenser/vent area for normal operation
• Replaces cracked, broken, or warped trim that can catch dirt or snag floor mats
• Restores secure mounting where clips or tabs have failed

• One trim/vent grille

• Remove power to the appliance before starting any work
• Usually installs by lining up tabs and snapping into place; use care to avoid breaking plastic clips
• If mounting clips are damaged, replace them before reinstalling the trim
• No special tools typically required;

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.

Phillips head mounting screw for dishwashers and ranges. Secures internal components and panels. Replace if stripped, rusted, or missing during repairs.