Parts for Kenmore 790.36909900 (79036909900, 790 36909900): Backguard Parts

Replace your range's cracked or worn touch pad control panel. This cosmetic part installs on the front console to restore the appearance and function.

Control console housing that covers and protects your range's touch pad buttons and display. Replace if cracked, broken, or worn to restore appearance.

Replace your range's touch pad control panel if it's cracked, unresponsive, or physically damaged. This panel installs on the front of your range.

Fix a range that won't heat, has a blank display, or shows error codes with this control board. Common repair for unresponsive oven controls and timers.

Small mounting clip that secures interior range components in place. Replace if cracked, broken, or missing to prevent parts from shifting or rattling.

Replace your worn, cracked, or missing range trim. This cosmetic finishing piece installs around the edges or front panel to restore your range's appearance.

Range oven door gasket seals heat inside for efficient cooking. Replace if torn, brittle, or causing heat loss. Confirm fit with your model number.

Hex nut for gas range assembly. Secures components throughout your range. Replace if stripped, corroded, or missing during repairs or maintenance.

This service data sheet is a manufacturer-issued service document that helps technicians identify appliance specifications and troubleshooting information for repairs. It provides clear, printable reference material for diagnosis and service planning. What it does:

• Supplies official service information used during diagnosis and repair
• Helps locate error code meanings and recommended troubleshooting steps
• Often includes wiring diagrams, component locations, and specification data
• Useful for confirming proper procedures and service limits before disassembly

• For reference only; not a wearable or functional replacement part
• Always disconnect power to the appliance before performing any service
• Keep the sheet with the appliance service records for future diagnostics

This wiring diagram is the factory schematic label used to identify an appliance's electrical circuits and connector locations, helping technicians and owners troubleshoot electrical issues. What it does:

• Shows wiring paths, connector numbers, and component references in a clear schematic
• Helps locate and identify wire colors and terminal positions during diagnosis or repair
• Replaces a missing, damaged, or illegible factory wiring label
• Supports safe troubleshooting when paired with proper electrical testing procedures

• One factory wiring diagram sheet/label

• Always disconnect power to the appliance before inspecting or replacing the wiring diagram
• Affix the label where the original wiring diagram was located; avoid covering ventilation or moving parts
• Do not use the diagram as a substitute for hands-on electrical testing—verify circuits with proper tools

Mounting screw for ranges, ovens, and cooktops. Secures panels, brackets, or internal components. Replace if missing, stripped, or damaged.

Mounting screw for electric range, oven, or wall oven assembly. Secures internal components and panels. Replace if stripped, missing, or damaged.

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Specs: 8 - 18 x 0.500

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head