Parts for Kenmore 790.42513314 (79042513314, 790 42513314): Backguard Parts

Replace your range oven light assembly when bulbs burn out or the socket fails. Restores interior visibility for safe cooking. Verify fit with your model.

Control console housing that covers and protects your range's touch pad buttons and display. Replace if cracked, broken, or worn to restore appearance.

Range buttons not responding or display blank? This control panel assembly houses buttons and display for temperature selection. Restores full function.

Oven not heating or buttons unresponsive? This electronic control board manages temperature, timer, and cooking modes. Requires electrical knowledge.

Replace your range's worn, peeling, or faded touch pad overlay. This adhesive label restores clear control panel graphics for easy operation and readability.

Replacement control knob for range burner settings. Installs on cooktop control shaft. Needed when original knob is cracked, broken, or missing.

If your range burner won't turn on or off properly, or the indicator light stays on when turned off, this infinite switch restores control. DIY repair.

If your dual burner stays on low and won't turn off, or the small element doesn't heat, this infinite switch may need replacing. DIY-friendly repair.

Molded support sleeve that aligns and stabilizes rotating shafts in your range. Replace if worn, cracked, or causing excessive vibration or noise.

This is a replacement screw used to secure appliance panels and components. It restores proper fastening so panels, trim, or assemblies stay tight and reduce vibration or rattling. What it does

• Fastens panels, brackets, or trim to the appliance chassis
• Helps stop loose or vibrating panels and trim pieces
• Restores proper alignment where a missing or stripped screw causes gaps or movement
• Use when the original screw is missing, damaged, or corroded

• One replacement screw as shown

• Disconnect power to the appliance before starting any repair
• Use the correct screwdriver or bit to avoid stripping the screw head
• Tighten until snug; avoid over-torquing which can strip threads or crack plastic
• Keep removed screws in a safe place; this screw matches the original before installation

Heat-resistant gasket seals between cooktop and control panel components. Replace when cracked or damaged to contain heat and prevent spills. Verify fit.

Wire harness for electric ranges. Connects electrical components inside your range. Replace if wires are damaged, melted, frayed, or connections are loose.

Replacement mounting screw for ovens and ranges. Secures panels, brackets, trim, and internal components. Replace missing or stripped screws to restore fit.

Chrome screw secures handles, door trim, and internal components in ranges and ovens. Replace if lost during cleaning, stripped, or missing after moves.