Parts for Kenmore 790.46613500 (79046613500, 790 46613500): Backguard Parts

Spacer for ranges and ovens. Maintains proper spacing between components. Replace if worn, cracked, or missing to ensure correct alignment and fit.

Replace a cracked or missing power board spacer in your range. This insulating bushing mounts between the control board and chassis for proper spacing.

Mounting screw secures heating element to cooktop surface. Replace if stripped, rusted, or missing to ensure proper element installation and stability.

This is a black rubber gasket that seals the area between the control panel and the range body, preventing heat, grease, and moisture from reaching the internal wiring and controls. It helps protect sensitive electronic components from damage caused by exposure to cooking heat and spills. Replace this gasket if it is cracked, brittle, missing, or if you notice heat or moisture getting behind the control panel.

A wiring diagram schematic sheet that shows the electrical layout and circuit connections for the appliance, making troubleshooting and repairs easier by providing a clear reference of wiring paths and component interconnections. What it does:

• Provides the factory wiring schematic to identify wire colors, connector locations, and circuit routing
• Helps diagnose electrical faults by showing how components are wired together
• Useful for connections after replacing controls, harnesses, or components
• Reduces guesswork during repairs and makes tracing shorts or open circuits faster

• One original wiring diagram schematic sheet

• Reference the diagram before disconnecting power or removing covers
• Always unplug the appliance or shut off breaker before inspecting or working on wiring
• Use the schematic only as a reference; connections visually and with a meter during service
• Handle the printed sheet carefully to avoid tears or smudges that could obscure details

Specs: 8 - 18 x 0.500

Replacement #8 x 0.500 inch screw for securing panels, trim, and brackets in appliances. Needed when original fasteners are stripped, lost, or missing.

Fastens panels, brackets, and covers inside your range or oven. Replace this screw if missing, stripped, or rusted to secure components properly.

This replacement screw secures appliance panels, brackets, and internal components. It restores a tight, rattle-free fit and proper alignment when an original fastener is missing, stripped, or corroded.

• Fastens metal or plastic parts to the cabinet/frame
• Helps maintain alignment and reduce vibration or rattling
• Direct replacement for lost, damaged, or rusted hardware
• Keeps covers and brackets safely in place

• Disconnect power before servicing; for gas appliances, also shut off gas supply
• Match one-for-one with the original screw; verify length/type before installation
• Start threads by hand to avoid cross-threading; tighten snugly without overtightening
• Use the correct driver bit to prevent stripping the screw head