Parts for Kenmore 790.74334311 (79074334311, 790 74334311): Backguard Parts

This door hinge cover shields and protects the refrigerator hinge area from dirt and damage while giving the hinge a finished appearance. Replaces a worn, cracked, or missing cover to restore proper fit and appearance. What it does

• Covers and protects the door hinge assembly from debris and accidental contact
• Helps maintain a finished look by hiding hinge hardware and mounting fasteners
• Prevents sharp edges from being exposed, reducing snag and scratch risk
• Commonly replaced when cracked, broken, or missing after impact or wear

• One door hinge shield

• Remove power and open the door before servicing to prevent injury
• Typically installs with a few screws or clips—retain original fasteners unless replacement specified
• Handle part carefully to avoid scratching painted surfaces; align shield before tightening

This control panel overlay is the decorative front layer for your appliance's control area, restoring a clean, legible appearance and protecting the underlying switches and electronics. Ideal when the original overlay is cracked, faded, or worn. What it does:

• Covers and protects the control board and buttons from spills, dust, and daily wear
• Restores button labels and graphics for easier reading and operation
• Helps prevent debris from reaching switches that can cause erratic behavior
• Improves the appliance's cosmetic appearance when the original is discolored or damaged

• One control panel overlay

• Disconnect power to the appliance before beginning any work
• Installation typically requires removing the control housing; save fasteners and note screw locations
• Handle the overlay carefully to avoid scratching printed graphics; use non-marring tools if prying

The Oven Control Board is an OEM part for Frigidaire ranges. It is the central processor that regulates all heating functions, cooking modes, timers and safety features through electronic controls.

Causes of a bad control board can include moisture infiltration over time, loose connections, or component failures due to power fluctuations or surges.

Symptoms of a bad oven control board include:

• Elements not heating or cutting off as programmed
• Inaccurate temperature readings or inconsistent regulation
• Bake and broil modes not functioning properly
• Constant error codes or safety lockouts displayed

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

The Overlay is an OEM part for Frigidaire ranges. It provides the protective plastic face that interfaces with the electronic control buttons and display.

Causes of a bad overlay can include cracks or breaks from repeated cleaning, warping or discoloration from heat exposure over time, and physical damage from impact.

Symptoms of a bad control board overlay include:

• Non-responsive or inoperable control buttons
• Illegible or faded labels and display graphics
• Gaps or loose fit of the overlay allowing moisture ingress
• Premature wear reducing the overlay's protective function

This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.

A replacement control knob for appliance control panels that restores a secure, easy-to-turn interface for selecting temperatures and functions. Fits the original control shaft to make adjustments smooth and reliable. What it does:

• Replaces a cracked, stripped or missing control knob so you can accurately select oven/range settings
• Provides a clear pointer for the control shaft to indicate selected temperature or function
• Push-on design fits the appliance's splined control shaft for a snug, slip-free grip
• Common symptom fix: loose, spinning or missing knob that prevents changing controls

• Disconnect power to the appliance before servicing.
• Remove the old knob by pulling it straight off the control shaft; install the new knob by pushing it onto the splined shaft until fully seated.
• If the knob is tight or hard to remove, use a cloth for grip and pull straight; avoid excessive force that could damage the shaft.

The Gas Range Knob is an OEM replacement part for Frigidaire gas ranges and cooktops. It serves as the interface for selecting and adjusting the heat level on gas burners through a simple turn mechanism. 

Symptoms of a bad gas range knob include:

• Difficulty turning the knob or slipping/jumping movements
• Knob appearing loose, cracked or damaged
• Inability to accurately select low heat settings  
• Burner flames not responding as expected to knob position

Causes can be attributed to normal wear over extended use as knobs are rotated frequently during cooking. Exposure to excessive heat or impacts may also degrade plastic knob components.

This OEM Frigidaire replacement is compatible with Electrolux, Gibson, Kelvinator, and some Kenmore models.

This front control panel provides the user interface cover for your appliance, restoring access to buttons and display and improving appearance when the original panel is cracked, faded, or damaged. Fits the factory OEM mounting points. What it does

• Replaces a cracked, broken, or worn front control panel so buttons and display are protected and accessible
• Restores the original fit and look of the appliance's control area
• Helps prevent dust and moisture from reaching electronic controls
• Useful when the existing panel is scratched, warped, or no longer secures properly

• Disconnect power to the appliance before starting any service
• Remove screws or clips holding the old panel and note screw locations for reinstallation
• Handle with care to avoid scratching the new panel and to protect any attached wiring or trim
• If panel attaches to switches or PCB, verify connections before powering on

This is a replacement mounting screw used to secure the dual safety valve assembly on compatible gas ranges and ovens. It restores proper fastening so the valve stays firmly in place during operation. What it does

• Secures the safety/dual gas valve to the appliance chassis or manifold
• Prevents valve movement that can interfere with burner operation or alignment
• Commonly replaced when original screw is missing, stripped, or damaged
• Matches OEM thread size and length for correct fit and retention

• One (1) screw, size 10-16 x 0.486

• Disconnect power and shut off gas supply before starting work; follow all safety procedures
• Thread carefully to avoid cross-threading; do not overtighten — snug to OEM torque specification
• Inspect surrounding mounting holes and hardware; replace any stripped or damaged parts for a secure fit

The Screw is an OEM part for Frigidaire ranges and ovens. This part is designed to securely fasten various parts of the appliance, ensuring stability and durability. 

Over time, screws can become loose due to the expansion and contraction of materials with temperature changes. Regular use and the occasional necessary removal for repairs or cleaning can also wear down the threads, making them less effective.  

Symptoms of a bad Screw (Chrome) include:

• Loose or wobbly components that should be securely fastened.
• Difficulty in securing parts due to stripped or damaged screw threads.
• Visible corrosion or deterioration of the screw.

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Size: 8-18 x 0.5 inch. Color: Chrome.

The Screw is an OEM part for Frigidaire ranges and ovens. This part is designed to securely fasten various parts of the appliance, ensuring stability and durability. 

Over time, screws can become loose due to the expansion and contraction of materials with temperature changes. Regular use and the occasional necessary removal for repairs or cleaning can also wear down the threads, making them less effective.  

Symptoms of a bad Screw (Chrome) include:

• Loose or wobbly components that should be securely fastened.
• Difficulty in securing parts due to stripped or damaged screw threads.
• Visible corrosion or deterioration of the screw.

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Size: 8-18 x 0.5 inch. Color: Chrome.

The Screw is an OEM part for Frigidaire ranges and ovens. This part is designed to securely fasten various parts of the appliance, ensuring stability and durability. 

Over time, screws can become loose due to the expansion and contraction of materials with temperature changes. Regular use and the occasional necessary removal for repairs or cleaning can also wear down the threads, making them less effective.  

Symptoms of a bad Screw (Chrome) include:

• Loose or wobbly components that should be securely fastened.
• Difficulty in securing parts due to stripped or damaged screw threads.
• Visible corrosion or deterioration of the screw.

This OEM Frigidaire part can also be used on Electrolux, Frigidaire, Gibson, Kelvinator, Westinghouse, and Sears/Kenmore.

Size: 8-18 x 0.5 inch. Color: Chrome.