Parts for Whirlpool WFG320M0BB0: 03 - Backguard Parts

Color: White

Right Hand Endcap

Color: White

Left Hand Endcap

Color: Black

Right Hand Endcap

Color: Black

Left Hand Endcap

Factory replacement screw that secures appliance components and hardware. Use it to replace a missing, stripped, or corroded fastener to restore a tight, rattle-free fit and help prevent loosening or damage from vibration.

• Fastens brackets, panels, or internal parts at the original mounting points
• Replaces worn or missing hardware to correct loose or misaligned components
• Helps reduce vibration-related noise and movement
• Matches the original thread and length specified for the application

• Disconnect power; shut off water or gas if applicable before servicing
• Compare to the original for thread and length match before installation
• Start threads by hand to avoid cross-threading; tighten snugly—do not overtighten
• Reuse any original spacers/washers if present; replace if damaged

Replace your range control panel if buttons don't respond, the display is blank, or settings won't change. Direct fit for multiple models. Moderate DIY repair.

Replace your range control panel if buttons are unresponsive, the display is blank, or oven settings won't change. Moderately difficult DIY repair.

Replace your gas range control panel if buttons are unresponsive or the display is damaged. Restores oven and cooktop functionality. Panel only.

Replace your gas range burner deflector if it's cracked, warped, or missing. This metal component directs heat flow and protects internal parts.

This factory screw secures appliance components to their mounting points. Replace missing, worn, or stripped hardware to restore a tight fit, proper alignment, and quieter operation across the affected assembly.

• Fastens panels, brackets, covers, or internal parts to the chassis or frame
• Helps maintain alignment and support, reducing rattle, vibration, or looseness
• Replaces missing or damaged screws that have backed out, broken, or stripped
• Restores secure mounting after service when original hardware is lost

• Disconnect power; shut off water or gas supplies before servicing
• Use the correct driver; start threads by hand to avoid cross-threading
• Match length and thread to the original location; do not substitute with longer hardware
• Tighten snugly; do not overtighten into plastic or thin metal

Secures range components and panels to maintain proper alignment. Replace if your original bracket is cracked, broken, or missing to restore stability.