Parts for Speed Queen AFNE9RSP115TW01: Base / Side & Rear Panels Parts

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

Self-tapping pan head screw (10 x 5/8 in) for securing appliance panels, trim, and assemblies. Replace missing, stripped, or corroded fasteners.

Hex washer head screw for dryers and laundry centers. Secures panels, components, and internal parts. Replace if stripped, missing, or damaged.

This hole plug is a simple push-fit seal used to close a 1-1/8" diameter access or panel opening, keeping moisture, lint, and pests out and helping maintain appliance integrity. Fits common openings found on washers and dryer cabinets. What it does:

• Seals unused access holes in the cabinet to prevent water spray or lint intrusion
• Helps maintain proper airflow paths and prevents debris buildup
• Keeps pests and contaminants from entering the appliance interior
• Provides a neat, finished appearance where a service opening is not needed

• One hole plug (1-1/8" diameter)

• Disconnect power (and water, if applicable) before servicing the appliance
• Verify the opening is clean and the measured diameter is 1-1/8" before installing
• Push the plug into the hole until flush; some installations may benefit from a light sealant if a watertight fit is required
• If the plug is damaged or hard to seat, replace with the correct-size part to ensure a proper seal

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.

This replacement rubber foot cushions the machine's contact point with the floor to improve stability, reduce vibration, and protect surfaces. Replace a worn or missing foot to restore steadier, quieter operation and easier leveling.

• Provides a cushioned, non-slip contact point between the appliance and floor
• Helps absorb vibration and reduce rattling or movement during cycles
• Aids in proper leveling and overall stability
• Replace when cracked, flattened, or missing, or if the unit rocks or "walks"

• Disconnect power; for washers, also turn off water. If applicable, shut off gas supply
• Carefully tilt or raise the appliance with assistance and proper lifting support
• Remove the worn foot and install the new foot on the leveling leg or base as designed, ensuring it seats fully
• Re-level the appliance and tighten any locknuts; verify stable operation

Dissolves odor-causing residue and mildew buildup in washing machine tubs. Use every 30 washes to maintain freshness. Verify fit with your model.