Parts for Gladiator GABC05FDKG00: Beverage Center Parts

This thermistor is a refrigerator temperature sensor that helps the control board monitor and regulate internal temperatures for consistent cooling. Replaces a failed sensor to restore accurate temperature readings and proper cooling cycles. What it does:

• Senses air temperature and sends a variable resistance signal to the control board
• Helps the appliance run appropriate cooling cycles and defrost timing
• Faulty or out-of-range readings can cause warm compartments or excessive frost
• Compatible with systems that use a small probe-style NTC thermistor sensor

• One thermistor temperature sensor (single sensor)

• Disconnect power to the appliance before servicing to avoid shock or damage
• Handle the probe and wiring gently; avoid pulling directly on the wires
• Verify connector orientation and secure wiring to prevent loose connections

This evaporator fan moves cold air across the evaporator coil to keep the refrigerator compartment at the right temperature. Replacing a worn fan restores proper airflow and helps the appliance cool evenly. What it does

• Circulates cold air through the evaporator and into the fresh-food and freezer sections
• Helps prevent warm spots and supports consistent cooling
• Stops abnormal noises or vibrations caused by a failing motor or bent blades
• Reduces frost buildup tied to poor circulation

• One evaporator fan assembly

• Disconnect power before servicing to avoid electrical shock
• Remove interior panels or the evaporator cover to access the fan; retain screws and hardware
• Handle fan blades carefully to avoid bending; verify wiring harness connectors match before reconnecting
• After installation, restore power and listen for smooth, quiet operation and normal airflow

This Cover-Air protects and directs air flow around the appliance's blower area to help maintain proper ventilation and reduce debris entry. Replaces a worn or damaged air outlet cover to restore directed airflow and protect internal components. What it does:

• Channels and directs exhaust or circulating air from the blower or fan housing
• Shields the blower/fan area from falling debris and lint
• Helps reduce airflow restriction that can cause longer dry/cycle times or overheating
• Can reduce rattles or vibration caused by a loose or broken cover

• One Cover-Air replacement

• Disconnect power (and gas, if applicable) before beginning any repair
• Remove access panels or housing screws to reach the blower/fan area; retain fasteners
• Handle edges carefully; wear gloves to avoid cuts

This thermistor is the refrigerator temperature sensor that reports internal temps to the control board so the appliance can regulate cooling. Replacing a faulty thermistor restores accurate temperature sensing and helps stabilize cooling performance. What it does:

• Senses internal air or evaporator temperature and sends a signal to the control board
• Helps the refrigerator cycle compressors and fans at correct intervals
• Failing thermistors can cause incorrect temperature readings, frequent cycling, or temperature fluctuations
• Works with the control system; not a standalone temperature controller

• Disconnect power before inspecting or replacing the thermistor
• Handle the sensor and wiring gently to avoid damage; ensure connector is fully seated
• Route wiring per OEM wiring diagrams and avoid pinching when reassembling panels
• After installation, allow the appliance several hours to stabilize; the control board typically recognizes the new sensor automatically

This replacement fan moves air inside the appliance to help maintain even temperatures and improve cooling performance. It restores proper airflow when a worn or damaged fan causes uneven cooling or unusual noise. What it does:

• Circulates cold air through the compartment to promote consistent temperatures
• Helps reduce frost buildup by moving air past the evaporator
• Restores airflow if the original fan makes a grinding, rattling, or humming noise
• Supports normal compressor and defrost operation by enabling proper air movement

• Disconnect power to the appliance before starting any repair
• Handle the fan blades carefully to avoid bending or damage
• Verify correct orientation and secure mounting during reassembly
• Test operation after installation and listen for unusual noise or vibration