Parts for Broan HLB6: Blower Parts

This replacement plate serves as the appliance's mounting or cover component, restoring proper fit and finish and helping protect internal parts from debris and heat. Use when panels are loose, misaligned, or damaged. What it does:

• Covers and protects internal components from dust and grease
• Provides a secure mounting surface for adjacent parts
• Restores proper panel alignment and appliance appearance
• Helps prevent minor airflow or clearance issues caused by damaged panels

• One replacement plate as shown

• Inspect surrounding fasteners and gaskets; replace if worn before installing the plate
• Use appropriate screwdrivers and retain all original hardware
• Disconnect power to the appliance before accessing internal panels to avoid electric shock

Wire harness for vent systems. Connects electrical components to power the unit. Replace if wires are frayed, connectors damaged, or harness is missing.

Replace a worn vent system motor causing poor airflow or excessive noise. This motor powers your ventilation fan for proper air circulation and exhaust.

Rubber gasket for range hood vent systems. Seals connections between ducting components. Replace if cracked, torn, or deteriorated to maintain proper fit.

This flat washer provides a stable, even bearing surface for fasteners and helps distribute load to protect components from wear or loosening. It's a simple replacement part that restores proper fastening where a worn or missing washer causes movement or noise. What it does:

• Sits under a nut or screw to spread load and prevent damage to softer materials
• Helps maintain proper spacing and alignment of assembled parts
• Reduces loosening from vibration that can cause rattling or leaks
• Stops metal-on-metal contact that leads to wear or abrasion

• One flat washer

• Inspect mating hardware and replace any damaged screws or nuts for a secure repair
• Clean mating surfaces before installing the washer to ensure a flush fit
• Hand-start fasteners to avoid cross-threading; tighten to manufacturer torque specs if available
• Disconnect power or secure moving parts as needed before working on the appliance

A small flat washer used with fasteners to distribute load and protect surfaces on ventilation and range-hood assemblies. Replaces worn or missing washers to help maintain secure mounting and reduce loosening or damage. What it does:

• Sits under a screw or nut to spread clamping force and prevent pull-through
• Helps keep fasteners tight and reduces vibration-related loosening
• Protects finished surfaces from scratching or marring by metal hardware
• Used where a thin, flat spacer is required for proper assembly alignment

• One flat washer as shown

• Use correct screw or nut size and torque; do not overtighten to avoid deforming the washer
• Disconnect power to the appliance when removing panels or accessing fasteners
• Replace corroded or damaged fasteners together to ensure secure reassembly

Replacement mounting nut for fan and vent systems. Secures fan housing or motor components in place. Order if your original nut is stripped, lost, or damaged.