Parts for Ge ZET1038BF1BB: 03 - Lower Oven Parts

A replacement left cover that restores the exterior finish and protects internal components on the appliance. Fits where the factory left side panel was damaged, cracked, dented, or removed for service. What it does

• Covers and protects wiring, controls and internal parts on the appliance's left side
• Restores the appliance's appearance after impact or wear
• Helps stop drafts, rattles, and exposure caused by a missing or damaged panel
• Maintains proper clearance and helps keep debris out of internal compartments

• One left cover

• Disconnect power (unplug or switch off breaker) before starting repair
• Remove adjacent trim or access panels as needed to reach mounting screws
• Handle edges carefully to avoid cuts; use gloves if possible
• Tighten fasteners securely but avoid overtightening which can deform the panel

This roast rack is an oven insert that holds roasts and pans above the oven floor to improve air circulation and promote even browning. It restores proper clearance for drip pans and helps keep food out of accumulating juices. What it does

• Supports roasts, poultry and bakeware above the oven floor so hot air circulates evenly
• Prevents food from sitting in drippings for crisper browning and better roasting results
• Replaces bent, warped or missing oven racks that interfere with cookware stability
• Fits into oven side supports for secure placement during roasting

• One roast rack

• Allow the oven to cool and disconnect power before handling or replacing parts
• Slide the rack into the oven side supports until secure; ensure it sits level before use
• Use oven mitts when placing or removing hot cookware from the rack
• Clean by hand washing with warm, soapy water; avoid abrasive cleaners that can damage the finish

This hinge assembly supports and pivots the appliance door so it opens smoothly and closes flush. Replacing a worn hinge restores alignment and reliable latching to help prevent sagging, rubbing, or an uneven door gap.

• Provides the pivot point and support for the door
• Maintains proper alignment so the door closes and latches correctly
• Helps prevent door sagging, rubbing, or uneven gaps
• Common symptoms include a loose or misaligned door, difficulty closing, or squeaking/grinding at the hinge
• Replace if the hinge is bent, cracked, or binding

• Disconnect power at the breaker before servicing; wear cut-resistant gloves
• Support the door during removal and installation to avoid strain on the hinge
• Note hinge orientation and transfer original fasteners as needed
• After installation, verify the door closes evenly and latches without rubbing

This seal for the front frame creates a tight barrier between the oven door and frame to help retain heat and reduce smoke or odor escape. It restores a proper door seal to improve cooking performance and safety. What it does:

• Replaces worn, torn, or deformed front-frame gasket that allows heat or smoke to leak from the oven cavity
• Helps maintain consistent oven temperatures for more even cooking and baking
• Reduces heat transfer to surrounding cabinetry and surface areas
• Stops drafts, burning odors, or visible gaps around the door edge

• One seal for the front frame

• Disconnect power and let the appliance fully cool before attempting service
• Inspect orientation and seating before final installation; some models require door removal for access
• Use proper tools and gloves to avoid cuts; ensure seal is fully seated and continuous around the frame