Parts for Crosley 40540544A: Body|Bfcws3027asa.Svg Parts

Replace your cracked, warped, or discolored oven rack. Provides a stable surface for cookware inside your oven. Essential for even cooking and baking.

This is a door-activated switch that detects whether the oven door is open or closed. It controls functions such as the oven light or signals the control board about door position. Replace this switch if the oven light stays on or off regardless of door position, or if the oven does not operate correctly due to a faulty door signal.

Replace a cracked, broken, or missing oven door spacer that maintains proper alignment and gap between door components. Installs in door assembly.

If your oven temperature is inaccurate or food cooks unevenly, the temperature probe may have failed. This sensor monitors cavity heat levels.

This shield protects internal oven components from heat and debris. Replace if yours is bent, cracked, or missing to restore proper coverage.

Replacement door hinge for gas ranges. Installs on the oven door to allow smooth opening and closing. Replace if cracked, broken, or door sags.

This refrigerator door hinge secures and guides the door, restoring proper alignment and smooth opening. Replace a worn or damaged hinge to stop door sag, reduce rubbing or grinding, and help the door seal correctly. What it does:

• Supports the refrigerator door and keeps it aligned on the cabinet
• Guides door movement for smooth opening and closing
• Prevents door sag that can cause gaps and cooling loss
• Stops binding, scraping, or noisy operation caused by a damaged hinge

• Unplug the appliance or shut off power before starting any repair
• Support the door while removing and installing the hinge to prevent injury or damage
• Use the original fasteners or OEM-equivalent screws and tighten to proper snugness
• Check door alignment and gasket seal after installation; adjust hinge position as needed

This replacement evaporator fan blade helps circulate cold air inside the freezer or refrigerator compartment to maintain even temperatures and proper cooling performance. A direct-fit replacement when the existing blade is cracked, warped, or missing. What it does:

• Moves air across the evaporator to promote even cooling and frost prevention
• Restores proper airflow when a damaged blade causes noise or reduced cooling
• Helps reduce hot or warm spots inside the compartment
• Quiet, balanced operation when installed correctly

• One replacement evaporator fan blade

• Disconnect power to the appliance before starting any repair
• Typically accessed by removing interior panels in the freezer/refrigerator compartment
• Inspect the fan motor shaft and mounting for damage before installing the new blade

This is a mounting nut used to secure the fan blade to the motor shaft inside a range or oven. It keeps the convection or cooling fan firmly attached so it spins properly during operation. Replace this nut if the fan wobbles, rattles, or has come loose from the motor shaft.

This wiring harness supplies electrical connections between components, restoring power and signals for the affected circuit. It replaces a damaged or worn harness to help eliminate intermittent power or connection failures. What it does

• Carries power and signal between appliance components so controls and motors can operate
• Restores secure plug-and-socket connections when original wires or terminals are frayed or broken
• Helps address symptoms such as intermittent operation, blown fuses, or components not receiving power
• Matches OEM connector ends and wire routing to fit into the factory harness path

• Disconnect power (unplug appliance or shut off breaker) before beginning any repair
• Compare new harness to the old one to ensure connectors and wire lengths match before installation
• Route harness along the original path and secure with existing clips or ties to avoid heat and abrasion