Parts for Frigidaire MC1330E2: 05 - Body Parts

This part has been discontinued by the manufacturer and is no longer available.

This idler pulley guides and tensions the dryer belt to keep the drum turning smoothly. Replacing a worn pulley restores proper belt alignment and reduces noise for more reliable drying. What it does:

• Maintains belt tension and alignment so the drum rotates evenly
• Reduces squealing or grinding noises caused by worn bearings
• Prevents belt slipping and poor tumbling performance
• Helps avoid premature belt wear or breakage

• Inspect the belt and mounting bracket when replacing the pulley; replace worn components together
• Disconnect power before servicing and follow all safety warnings for your appliance
• Basic hand tools are typically required; follow your model's service manual for disassembly steps

This flat washer is a replacement fastener spacer that helps secure and evenly distribute load on screws or bolts in your appliance. Installing the correct washer restores proper fastening and prevents metal-on-metal wear. What it does:

• Provides an even bearing surface under a screw or nut to secure assemblies
• Helps maintain proper alignment of parts and prevents loosening from vibration
• Reduces wear and protects mating surfaces from damage
• Commonly used where a thin, flat spacer is required during reassembly

• One flat washer (quantity: 1)

• Turn off and unplug the appliance before starting any repair
• Replace only the washer(s) that match the original location and orientation
• Hand-start fasteners to avoid cross-threading; tighten to OEM torque if specified
• If the original washer shows damage or corrosion, replace it with this new part

A single #8A x 1/2" screw used to fasten trim, panels, and internal components on compatible appliances. Small but essential, it restores secure mounting and stops loose parts from rattling or shifting. What it does:

• Secures panels, brackets, and trim to the appliance chassis
• Replaces missing, stripped, or corroded screws that cause rattling or loose fittings
• Provides proper thread engagement for consistent, reliable fastening
• Helps maintain alignment of components that depend on a correctly sized screw

• Disconnect power to the appliance before working on any electrical or mechanical components
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and avoid overtightening; snug is usually sufficient for sheet-metal fastening
• Keep removed fasteners in a small container to avoid loss during reassembly