Parts for Frigidaire TGF331SCDB: 04 - Body Parts

Secures components inside your range. Replace if the original nut is stripped, corroded, missing, or no longer holding parts firmly in place.

These adjustable leveling legs support your range and allow you to level it properly on uneven floors. They screw into the bottom corners of the appliance and can be adjusted up or down. Replace them if your range rocks, wobbles, or sits unevenly, which can cause poor cooking performance and safety issues.

Replace your cracked, warped, or hard-to-clean oven rack. This durable rack installs inside your range oven to support cookware during baking and roasting.

Speednut fastener for ranges and ovens. Secures panels and components. Replace if stripped, missing, or no longer holds parts firmly in place.

Support plate that mounts to the bottom of your range oven cavity. Replace if the original plate is cracked, warped, or damaged from heat exposure.

This metal panel forms the bottom surface of your gas oven cavity. It protects the oven interior and helps distribute heat evenly during cooking. Replace it if you see rust, warping, or holes in your oven bottom that affect heating performance.

Body-side spacer for gas range door or lid hardware. Installs on cabinet side to set correct stand-off and alignment. Replace if cracked or missing.

Cover plate for gas ranges. Installs on the cooktop or control panel area. Replace if yours is cracked, broken, discolored, or missing for a clean look.

Secures panels and components in your range or oven. Replace if broken, bent, or missing to prevent shifting and reduce vibration noise. Confirm fit.

Secures range wiring to the cabinet to prevent loose or pinched wires. Replace if clips are broken or wires hang loose. Verify fit by model number.

Replace your gas range flue gasket to seal the flue opening and prevent heat loss. Install when worn, cracked, or damaged. Confirm fit with model number.

Directs exhaust and heat from the oven cavity to the range vent path. Replace this flue if yours is damaged, corroded, or missing for proper ventilation.

Replacement housing cover for your range. Installs on the exterior or internal housing assembly. Order a new cover if yours is cracked, broken, or missing.

Secures the oven bottom panel in place. Replace if screw is stripped, missing, or no longer holds the panel securely. Sold individually.

This clip is a small plastic retainer designed to secure trim and lightweight panels so they stay in place and reduce rattling or gaps. It restores proper fit and helps keep parts aligned for a finished look. What it does:

• Secures trim pieces, panels, or grill components to the appliance frame
• Prevents loose or rattling parts that can cause noise or misalignment
• Holds components in correct position so doors and panels close properly
• Replaces worn or broken clips that no longer grip reliably

• Remove power or disconnect the appliance before servicing when applicable
• Clip installs by snapping into pre-existing mounting hole or slot; no special tools usually required
• Inspect mating surfaces and replace any additional damaged fasteners for best fit

Replace your gas range's damaged or missing oven front cover. This cosmetic panel installs on the front of the oven cavity to restore appearance.